Polypropylene Fiber (PP Fiber) is made from 100% virgin PP
granular, after extruding from different mould and technology, we
can get 4 different types of fiber, including Monofilament form,
Fibrillated Mesh form, Twisted Bunchy and Wave form with different
size. These fiber can improve the reinforcement of mortar or
concrete performance effectively to make them strong and protect
the projects.
1. Easy to be dispersed in mortar or concrete and no agglomeration,
it can guarantee the property of crack resistance effectively.
2. Easy to be used: No need to change the proportion of mortar,
just put the fibers into the mortar mixture and stir for a moment
after adding water.
3. It with fine economic property: The equivalent diameter of PP
Fiber monofilament is only φ 0.02-0.03mm, so the ratio of diameter
and surface area is high and on the basis of crack resistance, it
can reduce the amount (to about 0.6-0.9kg/m 3 ).
4. Easy to plaster: As the great number of thin fibers spread into
mortar evenly, the plastering is much easily and this can improve
the binding strength between surface and base.
5. It with stable chemical property, strong acid &alkali
resistance, and can be used in any engineering projects.
APPLYING INSTRUCTION:
A). Compound Amount. To resist the common cracks on surfaces,
0.6kg/m3 fibers to cement paint is enough, and for reinforced
application 0.9-1kg/m3 is enough.
B). Stirring requirement. The proportion of cement, sand and
aggregate is no need to be changed. Put cement, aggregate, additive
and fiber together, then stir after adding enough water (Do not
stir without water!) and time for stirring can be prolonged for 2~3
minutes in order to make the compound mix completely.
Resist to shrink & crack | Increase seepage resistance |
Increase friction resistance | Increase freezing & thawing resistance |
Improve tendons protection | Replace steel net (using in plastering) |
Prevent mortar split and crackle expansion | Increase impact resistance and peeling resistance |
Suitable Project
1. Be suitable for the water–proof layer, floor, inner & outer wall
of industrial and civil construction.
2. Increase cracking resistance on the surface of industrial
workshop, warehouse and parking lot.
3. Increase cracking & seepage resistance of the ground in
natatorium, swimming pool, pond and ditch.
4. Be suitable for any mortar projects and fine aggregate concrete
projects.
Raw Material | Polypropylene | Fiber Type | Monofilament |
Length (mm) | 3/6/12/18/50... | Diameter (microns) | 18 , 34 |
Strength (Mpa) | 450, 600 min. | Crack Elongation (%) | 15-20 |
Melting Point (C degree) | 160-170 | Acid & Alkali resistance | Strong |
Packing: 0.6kgs or 0.9kgs per bag, 18kgs per carton.
Quantity: 400CTNS/20`FCL without pallet
900CTNS/40`HQ without pallet
